INSTALLING OLANDESE & DEA INSTALLATION SHEETS LAYING DIRECTION To install the sheets Olandese you have to follow an obligatory laying direction from left to right and an optimum overlap designed to obtain the maximum usable roof area (see the picture on the rightl. The longitudinal overlap must be positioned preserving the aesthetic continuity of the sheets. INTERSECTION OF 4 SHEETS On the right you can see in details the intersection between vertical and horizontal overlapping of Olandese sheet. DIRECTION DE POSE DES PLAQUES La Plaque Olandese doit obligatoirement etre posee de gauche a droite et en respectant le recouvrement etudie pour obtenir la meilleure couverture possible (voir le schema a gauche). Le recouvrement longitudinal des plaques doit etre positionne en gardant la continuite esthetique de la couverture INTERSECT/ON DE4 PLAQUES Agauche vous trouvez le detail de /'intersection entre recouvrement vertical et horizontal de plaque Olandese. RIDGE INSTALLATION WITH JOINTS INSTALLATION DE LA FAITIERE AVEC JOINTS 0 r adhe~iveside_lfote adhi sif ' ........ '--, The installation of Olandese ridge joints is very easy and it allows aperfect seal on side waves. Before drilling roof ridge and sheets make sure that the different parts of the roof are perfectly matched. •Joints must be installed between the sheet and the lower part of the ridge; it is recommended to put the joints as close as possible to the external edge to allow maximum compression and therefore the best water tightness of the whole covering (picture. 1) • Installation of the seal: clean the surface of the sheet with amild detergent solution, apply the adhesive side of the joint to the plate, remove the protection and fix it with a little pressure (picture 2) • Put the ridge onto the seal and pierce with a 10 mm drill. CAUTION: to optimize watertight the hole must be made on the upper part of the wave of the Olandese sheet and in the middle of the joint (picture 3) • Fix the ridge, joints and sheet Olandese to the underlying structure using aflat cap and 130 mm screws (picture 4) L'installation des joints pour la faitiere superieure de la plaque Olandese est une operation tres simple, qui permet l'etancheite complete de la toiture. • Lejoint doit etre applique entre la faitiere superieure et la t6le au dessous: afin de permettre la compression maximale du joint et, par consequent, la meilleure etancheite a l'eau, on conseille d'installer Les joints aux extremites de la faitiere (fig. 1) • Pour faciliter la pose du joint: bien nettoyer la surface de la plaque avec un produit non-aggressif, retirer la protection de l'adhesif, positioner le joint sur la plaque (le cote adhesifsur Les ondes et la surface plane vers le haut - fig. 2). • Positionner la faitiere superieure au-dessus dujoint et percer l'accessoire avec un foret de 10 mm Attention: le trou doit etre effectue en correspondance de la partie superieure de l'onde de la plaque Olandese et au milieu du joint (fig. 3), afin d'optimiser l'etancheite. • Fixer la faitiere, le joint et la plaque Olandese sur la charpente avec un cavalier universe/ et une vis de 150 mm (fig. 4) ADVISABLE DISTANCE OVERLAP MINIMUM SLOPE SUGGESTIONS ON NUMBER AND POSITION OF THE FIXINGS ENTRAXE CONSEILLE RECOUVREMENT PENTE MINIMUM CONSEILS SUR NOMBRE ET POSITION DES FIXATIONS 42
RkJQdWJsaXNoZXIy MTIzMjc4Nw==